smartctl 5.41 2011-06-09 r3365 [i686-linux-3.2.0-23-generic-pae] (local build) Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net === START OF INFORMATION SECTION === Device Model: TOSHIBA MK1646GSX Serial Number: Z7BGT09HT LU WWN Device Id: 5 000039 0b1783c1d Firmware Version: LB112D User Capacity: 160,041,885,696 bytes [160 GB] Sector Size: 512 bytes logical/physical Device is: Not in smartctl database [for details use: -P showall] ATA Version is: 8 ATA Standard is: Exact ATA specification draft version not indicated Local Time is: Sun Jun 10 00:26:56 2012 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 112) The previous self-test completed having the read element of the test failed. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 88) minutes. SCT capabilities: (0x0039) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 128 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0 3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1516 5 Reallocated_Sector_Ct 0x0033 100 100 050 Pre-fail Always - 82 9 Power_On_Hours 0x0032 072 072 000 Old_age Always - 694469 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 4087 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 7331 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 57 193 Load_Cycle_Count 0x0032 097 097 000 Old_age Always - 32354 194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 40 (Min/Max 6/54) 199 UDMA_CRC_Error_Count 0x0032 100 100 000 Old_age Always - 118766799 200 Multi_Zone_Error_Rate 0x0032 100 100 000 Old_age Always - 679900557 240 Head_Flying_Hours 0x0032 074 074 000 Old_age Always - 644468 241 Total_LBAs_Written 0x0032 100 100 000 Old_age Always - 17915968096 242 Total_LBAs_Read 0x0032 100 100 000 Old_age Always - 30338769854 SMART Error Log Version: 1 ATA Error Count: 1002 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 1002 occurred at disk power-on lifetime: 11561 hours (481 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 4a 45 1b ab 65 Error: WP at LBA = 0x05ab1b45 = 95099717 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 e0 70 e6 62 40 00 00:27:00.980 WRITE FPDMA QUEUED 61 10 d8 20 99 a0 40 00 00:27:00.980 WRITE FPDMA QUEUED 61 08 d0 38 e6 62 40 00 00:27:00.980 WRITE FPDMA QUEUED 61 08 c8 f0 77 a0 40 00 00:27:00.979 WRITE FPDMA QUEUED 61 10 c0 48 df 62 40 00 00:27:00.979 WRITE FPDMA QUEUED Error 1001 occurred at disk power-on lifetime: 11561 hours (481 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 3a 45 1b ab 65 Error: WP at LBA = 0x05ab1b45 = 95099717 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 b0 08 78 a0 40 00 00:26:00.975 WRITE FPDMA QUEUED 60 40 a8 10 97 17 40 00 00:26:00.601 READ FPDMA QUEUED 61 08 a0 e8 9e d3 40 00 00:26:00.601 WRITE FPDMA QUEUED 60 7b 98 68 a7 9f 40 00 00:26:00.601 READ FPDMA QUEUED 60 00 90 68 a6 9f 40 00 00:26:00.601 READ FPDMA QUEUED Error 1000 occurred at disk power-on lifetime: 11561 hours (481 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 4a 45 1b ab 65 Error: WP at LBA = 0x05ab1b45 = 95099717 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 60 60 05 f2 40 00 00:25:00.575 WRITE FPDMA QUEUED 61 08 58 e0 9e d3 40 00 00:25:00.575 WRITE FPDMA QUEUED 60 08 50 a0 eb 64 40 00 00:25:00.575 READ FPDMA QUEUED 60 20 48 28 1b ab 40 00 00:25:00.575 READ FPDMA QUEUED 60 07 40 18 4b 28 40 00 00:25:00.575 READ FPDMA QUEUED Error 999 occurred at disk power-on lifetime: 11561 hours (481 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 62 45 1b ab 65 Error: WP at LBA = 0x05ab1b45 = 95099717 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 e0 90 04 f2 40 00 00:24:00.973 WRITE FPDMA QUEUED 61 08 d8 08 78 a0 40 00 00:24:00.972 WRITE FPDMA QUEUED 61 08 d0 f0 9d 32 40 00 00:24:00.972 WRITE FPDMA QUEUED 61 10 c0 f8 98 a0 40 00 00:24:00.972 WRITE FPDMA QUEUED 61 08 58 f8 77 a0 40 00 00:24:00.972 WRITE FPDMA QUEUED Error 998 occurred at disk power-on lifetime: 11561 hours (481 days + 17 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 a2 45 1b ab 65 Error: WP at LBA = 0x05ab1b45 = 95099717 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 c8 00 78 a0 40 00 00:22:05.514 WRITE FPDMA QUEUED 61 08 c0 b8 8a 42 40 00 00:22:05.514 WRITE FPDMA QUEUED 60 07 b8 18 4b 28 40 00 00:22:05.514 READ FPDMA QUEUED 61 08 b0 08 78 a0 40 00 00:22:05.513 WRITE FPDMA QUEUED 61 08 a8 c8 98 a0 40 00 00:22:05.513 WRITE FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed: read failure 00% 11574 0 # 2 Extended offline Aborted by host 90% 11570 - # 3 Short offline Completed without error 00% 11570 - # 4 Short offline Interrupted (host reset) 90% 11570 - # 5 Short offline Aborted by host 50% 11570 - # 6 Short offline Aborted by host 80% 11570 - # 7 Short offline Completed without error 00% 11223 - # 8 Short offline Completed without error 00% 10838 - # 9 Short offline Completed without error 00% 10598 - #10 Short offline Completed without error 00% 10357 - #11 Short offline Completed without error 00% 10013 - #12 Short offline Completed without error 00% 9678 - #13 Short offline Completed without error 00% 9377 - #14 Short offline Completed without error 00% 8951 - #15 Short offline Completed without error 00% 8539 - #16 Short offline Completed without error 00% 8070 - #17 Short offline Completed without error 00% 7631 - #18 Short offline Completed without error 00% 7209 - #19 Short offline Completed without error 00% 6800 - #20 Short offline Completed without error 00% 6436 - #21 Short offline Completed without error 00% 6125 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.