Looking for a new fascia, please help!

You know how you always learn the hard way? Well, I was doing a "paint-the-fascia-to-match-the-dash" mod. It was going to look really good. It is a wrinkle type paint that I sampled and would blend really nicely. Well, to make the wrinkles, you have to apply a little heat. I set the piece next to a halogen lamp to accomplish this. Well, the lamp didn't seem that hot........ So anyhow it's not melted really, warped might be a better word.

To make a long story short (too late), I need another fascia (the ornate plastic plate the screws hold down, not the colored bits underneath it). If there is any source for just the fascia, or if anyone with a custom wooden one still has the old plastic piece around, or any other similar ideas, PLEASE let me know. I might just go buy a 30 to get another plate, but that might be excessive. I can pay for your troubles, just name a price.

I feel like such a bad dad right now, I hurt my baby

Sorry I can't help now, but I sure would like a new fascia that won't block the upper left view of the screen from where I will be installing my unit..

I prefer not to "scooch" the VFD down either.

Too bad there isn't anyone making a correctly design fascia that allows viewing from any reasonable angle...

-John M

Ah... ah... ah.. BWAHAHAHAAAA!!! (don't fret, I know tracer)

There are a few users here that have CNC custom fascias. Lovely wooden ones, even an aluminum fascia. Hopefully they will be generous enough to gouge, er, charge you for one.

Now that I think about it, my empeg is in my car because you helped me. Now I feel awful. Someone help the poor chap out.

Greetings!

I think I can do that.

Tracer - I have replaced two of my stock fascia with wooden ones. If you are interested in one of the originals, contact me via private message.

You have been PM'd. Thanks everyone for reading this, I think I may be taken care of. Whew!

Perhaps I can change my signature again!