Posted by: benjammin
Update to EMPEG FAQ - 26/02/2005 17:45
Hey there - who maintains the FAQ?
I was looking at the hiJack config.ini options and noticed the temp on and temp off options for the temp controller PCB's aren't in there....
Should/Could those be added?
-Ben
Did you check out the FAQ?
Quote:
· About Hijack FAQ.
(Entry last updated on February 15th, 2002)
This FAQ is not maintained by Tony Fabris or Mark Lord, so don't bug them about it. They're both busy enough as it is, which is why i'm writing this, not them. It's maintained by me, Loren Cox.
It's in it's infancy at the moment, and will grow over time to envelop the entire known galaxy.
I am not a programmer and don't pretend to be, so there may be people reading this who understand the innerworkings of Hijack better than I do. I take critique well and welcome any and all suggestions and additions. You can PM me on the empeg BBS, my username is loren, or email me at loren @ skivvies . com (minus the spaces).
Back to Top
Loren did the Hijack part of the FAQ, and Tony Fabris did the rest.
Posted by: loren
Re: Update to EMPEG FAQ - 26/02/2005 23:47
That would be me. I would be the one guilty of letting the Hijack FAQ fall into disarray. It is well out of date. If there are specific things you could write up that should be added, I'd love it if it were submitted to me, and I can post it.
I don't blame you Loren. Hijack is/was updated so frequently, that it's impossible to keep up. Your work did help me quite a bit with my config.ini settings though. Thank you.