Posted by: RobRoy
Wiring Harness Confirmation ? - 07/08/2002 17:31
Greetings All!
I am preparing the wiring harnesses for installation into a GM vehicle, and I would like confirmation on the conventions used:
Empeg Aftermarket Adapter
Black (Earth) <-----------------> Ground (Chassis Ground)
Yellow (Perm Power) <------> Yellow (12v Constant)
Orange (Ignition Sense) <---> Red (12v switched)
White (Headlight Sense) <---> Orange/White (Dimmer)
Blue (Amplifier Remote) <-----> Blue (Antenna/Amplifier)
Green (Mute Input) <----------> NOT PRESENT IN HARNESS
Is this correct? In particular, I am concerned about:
Orange <---> Red
&
White <-----> Orange/White
I just want to make sure it's correct and only solder it once.
Thanks!
Rob
I am preparing the wiring harnesses for installation into a GM vehicle, and I would like confirmation on the conventions used:
Empeg Aftermarket Adapter
Black (Earth) <-----------------> Ground (Chassis Ground)
Yellow (Perm Power) <------> Yellow (12v Constant)
Orange (Ignition Sense) <---> Red (12v switched)
White (Headlight Sense) <---> Orange/White (Dimmer)
Blue (Amplifier Remote) <-----> Blue (Antenna/Amplifier)
Green (Mute Input) <----------> NOT PRESENT IN HARNESS
Is this correct? In particular, I am concerned about:
Orange <---> Red
&
White <-----> Orange/White
I just want to make sure it's correct and only solder it once.
Thanks!
Rob