Model: MK2
Image: 3.00-alpha11 developer image
Upgrade: 60GB drive ~1.5 years ago
Since then, no changes to configuration.

Power up the unit, typical RIO banner, and initialization messages.
Unit goes into standby mode (pulsing power light). This has always occured.

Press power button. Nothing.

IP address does show up on net, though Emplode can not find Empeg.
USB does not connect either.

With Hyperterminal, there's a few errors about mounting hda, though searching the forum, some of these appear normal.

Now that I'm at a BASH prompt, is there something I can review that might give me insight that it is (or is not) a software/disk problem?

Or even issuing a "force unit on" command? This to decipher if it's a not the power button.

I can post the full boot up if necessary. Just want some initial advice

Thanks guys