I decided to test out v389, but as I require ext3 I decided to compile it up as Mike hasn't as yet. I'd done them in the past so I thought why not (although last time I tried was before Mark was splitting each revision (so about v300).

Anyway, I started with a clean slate as far as the empeg source were concerned. I untared the v387 and applied the 2 patches to that.

Then did the the rest.

Anyway during the build it fails with :-

arm-empeg-linux-gcc -D__KERNEL__ -I/data/empeg/tarballs/kernel/v389/include -Wall -Wstrict-prototypes -O2 -fno-strict-aliasing -pipe -msoft-float -march=armv4
-mtune=strongarm110 -c -o time.o time.c
time.c:68: redefinition of `mktime'
/usr/local/armtools-empeg/lib/gcc-lib/arm-empeg-linux/2.95.3/../../../../arm-empeg-linux/include/linux/time.h:71: `mktime' previously defined here
time.c:86: warning: `do_profile' defined but not used
make[1]: *** [time.o] Error 1
make[1]: Leaving directory `/data/empeg/tarballs/kernel/v389/arch/arm/kernel'
make: *** [_dir_arch/arm/kernel] Error 2

Oh at this point I haven't changed the .config file to enable ext3.

Any ideas?