I don't have a small enough screwdriver to lift up the tray,

Don't fall into the trap of thinking those tiny little screws need a tiny little screwdriver.

The cross-slots (whater you call them) in those screws is actually quite large compared to the size of the screw itself, and a standard #2 Phillips screwdriver is what you want to use.

Using a smaller screwdriver (like a jewelers screwdriver) will only strip out the heads. On Phillips head screws, always use the largest screwdriver that will seat fully to the bottom of the screw head. The empeg's drive cradle screws take a surprisingly large screwdriver.

tanstaafl.