Hi yall,

Life has been busy but I finally have a little time this week to finish hooking my empeg in my car. I have it in the trunk interfaced thru a small computer to a kenwood video display using empegface. This is working great.

On the other hand my steering wheel control interface is not. I have a sony stalk converter hooked from the car to my empeg tuner. Using Mark's button display I can only receive raw stalk values from 3 of the six steering wheel buttons and the horn. What I believe is happening is the 3 non-working buttons after going thru the stalk converter have ADC values out of usable range.

My question is: is there a way to shift all of the voltage values a scale higher or lower to put all the values in range?

Thanks