Quote:
the track going to LED8 could easily be moved


But there are components on (at least) one side of each edge. The LEDs themselves can't be moved but the tracks could be re-routed.

Perhaps it the connector was short enough? Hmm.

Edit: No, I don't think a connector will work. The drawing isn't quite to scale (I did say it was pre-CAD) - that PIC gets pretty close to the edge. I also need the ability to reprogram the device, so part-populating the board then flashing the device isn't going to be a solution.


Edited by mdavey (22/12/2004 22:22)
_________________________
Michael
Ex-owner of stolen empeg #030102741