Hi Everyone...

Forgive my idiocy. My Empeg stopped working - got the No Hard Drive Found warning. I took it out of my car and noticed a slight rattling. Upon opening it up I found the jumper had fallen off the drive selection jumper pins. I assume the jumper goes on the furthest drive to designate it as Drive 1, Drive 0 being closer on the ribbon cable to the main board connector. Is this correct? Also - is it cable select or do I have to ID the 1 and 0 drives implicitly? I believe there was only one jumper. These are 2 80 GB Fujitsu drives. There are 3 choices for jumper configs, drive o, drive 1, or cable select.

Thanks Everyone.

Joe