I recently had a couple of wires pull out of my loom, which i tried to solder back in with my limited soldering skills. They subsequently pulled out again, so i sent an email to the support guys and after a month of anxious waiting got my new loom in the mail... So here's my question..

For those that got the new "soldered" looms... where is the solder? Should it be visible on the crimp connections on the docking connector? The one i was sent has no trace of visible solder, and some of the crimps see pretty shoddy with wire hanging half out of the crimp, and on top of that one of the connector pins is bent down. I just wanted to make sure i got a new soldered version and not an old one that was laying around, namely cause i don't want to have to take my dash apart again in a month when these pull out... not to mention my warranty is up in less than a month. Thanks!


|| loren.cox ||