I will note that a few months ago, the empeg would sometimes get stuck on the last song played. Which eventually became constant. I performed a software upgrade again, and life was good.

Now when I power up my empeg, the bottom status line says "Searching for music..." I've been using v 3.00-alpha11 consumer version all along.
I sometimes get a brief "flash", like it just did a redisplay.

I connected via serial to a command prompt, and it did mention e2fsck needed to be run. I could not find e2fsck, so I did it manually with fsck commands).
Still says e2fsck needs to be run. And still getting the "Searching for music...".

Since it's in this mode, I cannot connect via Emplode, none of the buttons respond.

Any suggestions as to what to post to help diagnose this?

Thanks.