My empeg has gone crazy, i tried to do a drive upgrade with a 30GB drive and i run the .upgrade file and everything was going fine and then it failed with the error "Error Couldnt find pump". Now when i plug in my empeg the hard drives dont even spin up. The blue link light stays on even when nothing is hooked up to it and also the flashing standby light stays on . Also when i plug up the empeg and look at the hyperterminal output i just get this.

empeg-car bootstrap v1.02 20001106 ([email protected])
If there is anyone present who wants to upgrade the flash, let them speak now,
or forever hold their peace...If there is anyone present who wants to upgrade th
e flash, let them speak now,
or forever hold their peace...If there is anyone present who wants to upgrade th
e flash, let them speak now,
or forever hold their peace...If there is anyone present who wants to upgrade th
e flash, let them speak now,
or forever hold their peace...If there is anyone present who wants to upgrade th
e flash, let them speak now,


And that just repeats itself over and over. There is also a red solid light on the board.