Just wondered if the other MK2 users could check their front panel LEDs. Mine seems partially obscured by the front panel. When I was re-seating the front panel, I had a peep behind the colour facia, the LED seems to have been soldered pointing slightly upwards, which aims it to the edge of the facia. Not a major problem, but it's worse when you view it from the right side, i.e. when it's mounted in the car dashboard in a RH drive vehicle.

Same here. When Mk2 is sitting on the desk at work, the front panel masks the led almost completely out. It can be fully seen only when looking from lower left corner to the unit. Not a big problem, though.

One other thing on the front panel. The mask is inclined compared to the handle so that turning the handle causes it to take contact with the mask around the left hinge area. I could imagine this to scratch the paint a bit around that area on a long run. Has anyone else noticed this?

Overall, I really like the new front panel. As the screen looks like embedded to the fascia, it gives much more depth to the unit. Opposite to Mk1 where the screen and buttons seemed to be in same plane, especially as the fascia didn't have any border roundings.

Kim