hopefully that is the clue to the problem, since when i was about to loadthe .OBJ file into the pic i got a error whitch i cant recall rigth now, but after a phone call to a company who designs pic programming hardware/software, he told me to delete the lines 43,44 and 45, in the .OBJ file because they were wrong and shouldnt be there at all because the call upon adresses that dont exist in a PIC12c508 chip. i followed his words and the programming went ok, but when i connect it to my empeg i get no response at all. by the way, i dont have the empeg docked because my car got fed up with me so nw its getting a service. does the empeg need to be docked? do i need any extra software on the empeg except hijack? any changes to config.ini? i know nothing about this?