My empeg player has once more a problem with the detection of the power source (AC or DC). My player was once in for repair because of this. A buffer chip was blown then. Since the repair it worked as expected.
But now my player always thinks it is on DC power. The switch in the power jack is ok.

The problem is, you can only flash the player with a new firmware if you are on AC Power. (To speed up the boot in the car)
Even with hijack installed it is not possible to force AC power at this stage of the bootloader.

So I can't upgrade my empeg at the moment. Correct? (At the moment hijack is not installed) Any ideas on how to upgrade the player/hijack software?

Maybe the same chip had blown again or could it be another one this time? Maybe someone from support can give me some hints what to check or to replace.