Woot! I'm done, and listening to the radio! I had to make a few minor deviations, from pca's instructions, though. I didn't do a good job on wiring the antenna to the lower PCB, and the inner core ended up touching the RFGND hole. The VN02s on the lower PCB also didn't stick up over the top PCB, and slipped under to rest on the leads on the underside of the top board. Then I ended up scraping a bit of insulation from the shielded two core wire while trying to shove it through that stupid hole. A bit of electrical tape fixed all three.

Uhh.... okay.... forgot to uplug the soldering iron... gotta go before the cats get on the table...

Thanks to pca for providing the tuner kit. It was a very enjoyable project.