Thank you for your posts,
but I can't find any loose pins on the IDE Conector even under magnification.
I have built the HD with the diskbuilder image on my Mark 1 and installed the consumer image and everything is fine.
Afterwards I took the HD with the same IDE Cable from my Mark 1 to my Mark2 and the following things appear on the log.
Code:
ide_data_test: wrote 0x0000 read 0x0100
ide_data_test: wrote 0xffff read 0xffff
ide_data_test: wrote 0xaaaa read 0xabaa
ide_data_test: wrote 0x5555 read 0x5555
hda: IC35O030ATEA14-0! ! ! ! ! ! ! ! ! ! ! !, ATA DISK drive
ide_data_test: wrote 0x0000 read 0x0100
ide_data_test: wrote 0xffff read 0xffff
I hope the cable is compatible and the partition of the HD is also compatible between Mark 1 and Mark 2 ?
Maybe I should take the Motherboard out of the empeg and look under the back side if something is loose or would it help using Contact spray? Or could I take a gauge to measure the pins?
I have no other ideas.
Helli
Previous Topic
Index
