- Must be a Mark2
- Must be hooked up in advance, hyperterm must be past its bootup screen and waiting (don't try to start hyperterm and boot the empeg at the same time)
- Hyperterm settings must be exactly right
- Need good cable
- Need zero IRQ conflicts with the serial port

Yes to all requirements above my routine is start hypertrm,open .ht settings saved for empeg then plug-in empeg & hit ctrl-T as quickly as I can but it continues to show the usual bootup info, ? I have the developer version (1.03 beta 6) or should it be consumer version?


#695empeg-car Mk2GRN& a mere 12Gig
"buyers regrets,NO"