Hi Hugo,

I'm just trying to make sure I understood correctly how the stalk interface on the tuner module works.
The Tuner module translates the analog values it gets from the stalk remote into binary values (named as ADCx below). It then transmits those values to the empeg via the RxD line of the empeg's serial port (the one that is also available on its back/the serial connector of the sled). The format it uses to transmit the values simple: a four character string that consists of the following characters:
0x02 - indicates a command from the stalk interface
0x00 / 0x01 - indicates that the shift switch is off / on
ADC1 first sample read from the remote
ADC2 second sample read from the remote
Right?

cu,
sven

proud MkII owner (12GB blue/green/smoked, was #080000113 is #090001010)