Originally Posted By: mlord
Specifically pay attention to anything with "delayed_rotate" in the name.


Thanks for the tips! I will check this out when I get time.

Originally Posted By: julf
Any hope of having your implementation also run on a rio receiver?


I'm not sure if the Rio Receiver has enough CPU. I see about 50% utilization on the empeg (IIRC) when playing high bitrate stuff. The RR CPU is a lot slower. I remember when I played around with SlimRio that I had to reduce the sampling rate or else it would cut out.

The support for empeg is in the SqueezeSlave trunk so you can download the source and give it a shot.

Originally Posted By: Redrum
Hopefully my recent replacement will last a lot longer since it is rated at one million cycles rather than 15k.


I think I have the same encoder as yours, just the through-hole version. I needed to cut down the shaft as you did as well.