I hope your pictures aren't as cropped in the install manuals.

No, what I posted was about 3% of the frame (I told you they were high-res ) The manual will show the full frame to make it easy for people to get their bearings.

Also are you sure that side of the crystal you are connecting to is the OSC_OUT (pin 64) side?

I never traced it out. I tried both sides actually, in an effort to avoid using a buffer, but I got the same results from either side, so I didn't really worry about it. After adding the buffer circuitry, the output from the digital out board is rock solid, so I don't think there is anything wrong with my approach.

Stu