I wish that was configurable, but it's not, so I just wait a hair longer than I normally would.

http://www.tivocommunity.com/tivo-vb/showthread.php?s=&threadid=26530


Enter-Enter codes
-----------------
E-E stands for "Enter Enter". The following codes must be entered in the "Browse
By Name"screen. These codes are generally used to set values on the Tivo. You
enter the code, and the prompt will appear, along with the red recording light
coming on. You then enter the value. You then enter the code again to set the
value in, and the recording light will go off. It doesn't actually stop recording if you
happen to be recording something, however. Entering invalid values will cause your
Tivo to reboot, so be careful.

...

``E-E-Rewind - Lets you set the "Offset:". Defaults to 2000.

``E-E-FastForward - Lets you set the "Delay:". Defaults to 957.

``The Offset and Delay control the overshoot correction. When you set them, go to
any recorded program, play it, pause it, and press FF to do a frame advance. This
makes the new values you put in take effect. For 1.3 like correction, use Offset of
1000 and Delay of 750.


_________________________
Donato
MkII/080000565
MkIIa/010101253
ricin.us