nat (inside) 0 A.B.C.193 255.255.255.192 0 0

Tried this and get "inconsistent" error. Actually what happens when I get that message is it puts the value A.B.C.192 in the config...I guess it assumes I wish to refer to the network and not the PIX inside interface. In any event, this doesn't seem to be working either.

Also, I'm concerned with the fact that your gateway appears to be on a different subnet as your pix's outside interface

How so? With a subnet mask of 255.255.255.192, the "outside" interface is on the A.B.C.128 network, which should allow host IPs ranging from .129-.190

My outside router is .129, and my PIX (outside) is .130

Also, you might want to run the command 'clear xlate' after making these changes and before trying to get out through the pix

*nods* Thanks (though I was aware, and doing so).