There is only one disk attached, the 48gig. I haven't added any jumpers yet, because when I prepare the hd's they should always be master. (according to the FAQ - and it's the same with a PC)

Is it normal that the hd does not spin up during this stage? (when I add the car2.builder?)

Does the HD have to be put on the connector closest to the motherboard, or doesn't this matter? (I have connected it to this one, figuring that was the one the original 10gig was connected to)

Any ideas?

(I will watch this thread for about an hour an replie immediately, thanks!)

Riocar 10gig (for now) S/N : 10101747 red