There are tons of places online to upload 'plans' to produce PCBs from. Typically you need to provide Gerber files or equivalent from a PCB CAD program to board houses like 4PCB or use proprietary software from other board houses such as PCB123 or ExpressPCB. It usually ends up costing a minimum of $70 or so, although there may be some a little cheaper. It is probably cheaper just to etch your own. I need to make one for my player too, I guess I could get a few produced somewhere if there is enough interest, otherwise I'll just etch one here. Setup fees for the film, etc. are prohibitively expensive unless you make quite a few.


Stu