Got the board, got the parts, soldered and installed it. Works great, looks great! Thanks, Stig!

For the record:

The LED's on Lopan's current parts list are the large ones from Brian's first board, the large one with 3 LEDs. For me, this was a good thing, because I ordered just one of those LEDs and so it matched the three I had already. And I was able to squeak them, barely, onto the board and make them work.

However, if you're doing one of the new knob boards and putting the LEDs on it from scratch, you should go down to the next smaller size. From looking at Brian's page, he also uses a smaller size than what I used.

The big ones I had worked, but they were super tricky to make fit. I even had to cut away a portion of one of the contact pads on one of the LEDs to prevent it from grounding against a different trace..

Lopan, you might want to update the parts list so it has both sets of numbers.