Dignan
Quote:
Yours is extra impressive!

Why thanks. Not done yet!

ashmoore:
Quote:
Could you let us know what parts you used for this?

Let's see:

CPU water blocks: Dangen Den TDX
GPU water block: Danger Den Maze4
radiator: Danger Den double (with a pair of 120mm fans)
pump: Eheim 1260 from ???
reservoir: a kitchen storage bin from Storables (pretty generic, but nice lid)
hose: 1/2-inch ID polyester-reinforced PVC from West Marine (and a bit of 3/4" and 1" ID)
reservoir fittings: too-expensive Marelon through-hull fittings from West Marine (bedded with polyurethane caulk).
clamps: stainless hose clamps from hardware and marine stores
pump/radiator enclosure: from IKEA, doubles as end table
PC case: Lian-Li PC60 (nice open spot to make holes for the hose bibs)
Various other nylon and brass fittings: marine stores, Lowe's and ???
Eheim pump isolation mounts from frozencpu.com
DIY #2 pump isolation mounts (big-ass rubber stoppers): Lowe's

Impressed with the fit and finish on the Danger Den stuff. I used the fiber-reinfornced hose because of tight bend radii between CPUs/GPU and am glad I did. Went all 1/2" ID for more flow. Did not trust plastic hose clamps so went stainless.

TigerJimmy
Quote:
How do you keep the disk drives quiet?

No special care yet. They are a pair of Seagate 200GB SATA on a 3Ware controller. Seem darned quiet. The case is one that I had previously enhanced with some sound-deadening butyl sheet and some lead-foil-foam insulating sheet, so that helps, too

(edit: fixed Eheim typo)


Edited by jimhogan (28/12/2004 23:01)
_________________________
Jim


'Tis the exceptional fellow who lies awake at night thinking of his successes.