For the record heres how I wired it.

I broke the connections down into 4 groups. I then soldered the wires into these groups on the circuit board.

This is the group breakdown:

Group 1:
.1uf Cap
10UF cap
470 res
mid leg pot
ground out

Group 2:
last leg pot
3.3k res
left leg VR

Group 3:
10UF cap
mid leg VR
3.3k res
last leg switch side A
470 res

Group 4:
.1uf cap
Right leg VR
12V in
last leg switch side B

Other connections are:
Red LED wire to mid leg switch side B
Black LED to Ground
12V to Last leg switch side B
Out to map to second leg switch side A
In from map to third leg switch side A
first leg connected to mid leg on pot

I think thats it.
Does that sound correct so far?

(made some corrections)
corrected LED hookups