Hi All,

I've just discovered a really weird problem when my Empeg is in the car.

When I first insert the Empeg into the sled, then it powers up fine and Hijack shows that it's in DC mode. I then turn off the ignition, and let the player go into sleep mode (I've set the timeout to be 3 seconds).

When I then turn the ignition back on again, the player always boots up in AC mode. If I remove the unit from the sled, and re-insert, it always boots back up in DC mode.

I've checked all the obvious causes, including my ACC and +12V lines. I've changed the DC power jack, just in case the 'home' sensor was faulty.

I've also noticed that when the player boots up into AC mode in the car, I often get no sound from the line outs. Pulling it from the sled, or simply rebooting it via Hijack fixes the problem.

Has anyone seen this? Any hints as to where I might look next?

My player is an original Mk2, and I'm running 2.01 software.

Thanks,

Andy.