Hi,

The permanent feed means that there is no need for a de-thump circuit. One thing you may come across is that there's no ground on the serial connector due to a slight oversight (oops) - and as the cables are custom moulded, we can't change this. Just make sure your attached device uses car ground and there will be no problems.

Are you saying that the ground pin (5 from memory) on the DB'9 isn't terminated at the connector? If that's so, that's going to kill my RM-XS2 interface box which only connects to this cable and expects TX, RX, 12V & GND to be there! I have made no provision for externally flying ground lead. I'm off to get the AVO and check before I go off on a tangent. If so, what are your plans to recitfy the error?

Regards,



_________________________________________
John, (MK1 114-20G, MK2 15-36G).