Quote:
The dispaly does work when connected directly to the device.

There is no voltage between the 25 and 19 pins on the Tx board.

I was going to get a light set for this critter anyway. I'd be happy to send the whole rig in for that and pay for the repair or the undoing of my hamfisted install job.


I have his extender and Empeg here and found the problem. It seems the 3 volt fuse blew at some point. The display will work without it, but not completely or normally as certain components in the display such as the IR require 3 volts. The extenders need 3 volts for operation at all so this was the problem.

Stu
_________________________
If you want it to break, buy Sony!